Portable Spas
Typical topside display when it has water built up inside due to leaking heater or condensation.
Symptoms: It will play with ...
Fri, 15 Jan, 2016 at 8:02 AM
Deformed foam walls can occur when the liner has not been installed correctly from initial setup (not completely straight over the foam), or when the surfac...
Thu, 13 Dec, 2018 at 4:47 PM
NOTE: You can get a leak in the liner at the secondary intake connection if the hose is connected in the wrong order. Please refer to the attached vid...
Thu, 13 Dec, 2018 at 4:50 PM
Operation Pressing one of the Temperature Adjustment buttons will cause the LED display to flash. While it is flashing, set the desired temperature by p...
Wed, 8 Nov, 2017 at 9:31 AM
If you have noticed a reduction in circulation or heating or are getting error codes, there are a few things you can do to troubleshoot.
...
Thu, 13 Dec, 2018 at 4:55 PM
This is an instructional guide showing how to perform a back flush of the Portable Control Unit with a garden hose. If your Portable Control Unit...
Thu, 8 Mar, 2018 at 11:24 AM
The ideal maximum temperature on the Portable Control Unit is 104°F.
If your PCU only allows you to set the temperature up to 100°F or is display...
Thu, 13 Dec, 2018 at 4:57 PM
This is an instructional guide detailing troubleshooting tips to dismiss the E1 Error Code. The E1 Error Code has been implemented to indicate when...
Thu, 13 Dec, 2018 at 4:58 PM
This is an instructional guide detailing troubleshooting tips to dismiss the E2 Error Code. The E2 Error Code has been implemented to indicate when...
Thu, 13 Dec, 2018 at 4:58 PM
The E3 Error indicates a condition where the Temperature Sensor has sensed a high temperature (Greater than 113 F. / 45 C.) within the PCU before the wat...
Thu, 14 Mar, 2019 at 9:39 AM