Sound Pulse Audio System
Our hot tubs are equipped with the (Sound Pulse advanced entertainment system) featuring speakers and the latest Bluetooth (4.2) audio streaming capabilities and IPX6 rated (waterproof)
A Pin is required to connect - The PIN may be found in one of two locations:
- On a sticker near the serial plate - for reference see find the serial plate
- On the amplifier itself—this may require removing a panel to access, see below
To set up Bluetooth, please follow these steps:
Note: (This is a Cambridge spa and for illustration example only - Manufactured in Q1 2025)
1. The primary panels are situated beneath the topside control center, which is highlighted in red located at the primary side of the spa. | 2. Remove the primary right panel highlighted in yellow by detaching the vertical strip panels. Each vertical strip panel is secured with 2 (or more depending on the model) panel screws. |
3. After removing the panel, you will find a wired amplifier/transformer device labeled as 'Sound Pulse Bluetooth Amplifier** The password to connect to the spa's Bluetooth module should be displayed on the device
4. Once successfully connected, playback audio will confirm the successful connectivity
Note: If your spa is equipped with an older audio system, please refer to one of these matching articles below:
If you are experiencing issues with connectivity, check out our troubleshooting article for Sound Pulse* system link below:
For further assistance, contact us at serviceca@canadianspacompany.com or call us toll-free at +1 877-909-7727