|
The spa will need a full 13amp weatherproof socket for the 6-metre-long cable to plug into.
Below are the steps when setting it up;
- Make sure it will be on a flat and level surface.
- Clear the area for the spa 190cm + 50cm for the PCU unit which includes the pipes.
- Inflate the lid first until it's in its shape.
- Next up inflate the main bladder until it's to the shape with a little bit of give, the hot water will cause the bladder to get to its true size, and will take 1-2 weeks for this expansion.
- Keep the inlet and outlet caps (KK-10163) fitted on the inside.
- Make sure there is a filter inside the filter housing of the PCU.
- Fill the spa up with hose-temperature water only to just above the orange wavey lines on the inside.
- Connect your pipes for the heat, filtration, and jets, and make sure that they are straight with no kinks.
- Remove the caps (KK-10163), let the water flood the PCU system, and then with the star valve on the filter housing lid, turn anticlockwise and purge for 10-20 seconds until all the air escapes and all that is left is just water escaping, then tighten up.
- Set your spa water temperature and then press heat.
|
|
 | Input your own serial number similar to the above into the warranty registration.
click button below; |
|
|
|
Article published by Ali Green
