Canadian Spa Company Service

Connection Pipe O-Ring
(Pipe and connection o-ring PCU & liner/bladder side)
Will be either red or black
KK-10823

Filter Lid Assembly Large O-Ring
(Sits in behind thread of filter housing, just on the inside)
KK-10827

Inlet & Outlet Cap
(Screw on the inside of spa, where the water goes in and out)
KK-10163

PCU Pump Impeller
(Draws water down through pump)
KK-10781

 

Filter Lid Assembly Whole
(Sits on top of filter)
KK-10829

Filter Lid Bleed O-Ring
(Small black o-ring on the thread)
KK-11014 

Filter Housing Grid 
(Sits under the filter)
KK-10828 

The Short Connector That Screws Onto PCU for Jets And Water Out Of The Unit
(This is fitted to the PCU and secured clockwise)
KK-10919

The Long Connector That Screws Onto PCU For Water Into The Unit
(This is fitted to the PCU and secured)
KK-10920

Long Connector 30cm
(For Swift, Rio & Muskoka V2)
KK-10754
 

Medium Connector 25cm
(For jets only Swift, Rio & Muskoka V2)
(For all ports Grand Rapids only V2)
KK-10785

Short Connector 15cm
(For jets fitting to aromatherapy of Swift, Rio & Muskoka V2)
KK-10755

Aromatherapy Canister
(For jets Grand, Swift, Rio & Muskoka V2)
KK-10756

V2 Pipe Connector Female Thread
(Fits on ports of Swift, Muskoka & Rio Grande)
Comes with a black or red o ring
KK-10753

V2 Inflation Hose
(For inflating bladder spas and lid)
KK-10850

V2 Drain Cap
(For plastic drain pipe end)
KK-10096

V2 Top Foam Panel Cap Rio & Swift V2
(For on top of each between each foam panel)
KK-10792

(Top & Bottom liner, pool and bottom liner. Triangle for ports with jets at the bottom heat, and filtration at the top)

(Main inflatable bladder without outer skin. Triangle for ports with jets at the bottom, heat at the top, and filtration at the top)

(Lid outer vinyl, not the bladder)

(No outer vinyl, for on top style 73")

(No outer vinyl, for on top style 70")

(Rounded edge, for spas from 2017 onwards)